Belt -One of the major wearing parts of screw air compressor

The belt has good elasticity, can alleviate impact and vibration during work, and move smoothly without noise. When the load is too large, the belt will slip on the wheels, which can prevent damage to other parts and play a safety protection role.

Failure appearance:

poor belt elasticity. Troubleshooting: After the air compressor is turned off, the temperature in the standby body is cooled and there is no pressure, check the current state of the transmission belt. Because of the special structure of the screw air compressor, how to replace and adjust it depends on its tightness. If there are no serious problems such as deformation, you only need to install the bolts accordingly to make them meet the requirements. However, when it is damaged beyond repair, it must be replaced with a new one.

One of the precautions is that the tension of the belt must be consistent throughout and be prepared to prevent slipping. After installation, test run for about 30 hours and observe the changes. In fact, the most important thing here is strength. Mastering this degree can avoid accidents such as disconnection.

If the replacement and adjustment of the drive belt of the screw air compressor can be done well, it will also benefit the work of the motor and other accessories, which will reduce the load virtually. After completing all the steps, fix the machine head. It must be carried out in an orderly manner. The implementation must be rigorous and no errors can occur. In many cases, damages are caused by operating errors. Maintain sufficient vigilance, make adequate preparations, and make adjustments to the data in a timely manner.